PSS SunStation Solar Power System

We are working to develop the Princeton Field Reversed Configuration (PFRC) nuclear fusion power plant. We’ll be at the IAEA Fusion Energy Conference in London this month to present the latest news about PFRC.

We also build SunStation solar power systems. This probably makes us the only fusion company to have delivered fusion power (albeit from the sun) to the grid.

The following figure shows 24 hours of operation on a sunny day. The web interface is provided by the Outback OPTICS RE software.

The area from 14:30 to 17:30 is when cars are being charged. Power consumption is around 300 W including dishwasher, induction cooktop, refrigerator, lights, Internet, and a large screen TV. All of the lights are LED. The house has a geothermal heat pump. The heat pump also preheats water for a gas hot water heater. The house has an energy recovery ventilator that exchanges air every 3 hours. Over three times as much power was sent to the grid as was taken from the grid!

The black bars are the load. Note the jump when a 2021 Ford Mach-E is connected. The Mach-E uses an Aerovironment L2 charger. A 2018 Toyota Prius Prime is also charging. The Prime uses a wall plug and a charging cable. PSE&G has a new program for discounted electric power after 9 p.m. for electric car charging.

Here is a partly sunny day.

The following image shows the power flow. The Lithium Iron Phosphate batteries are at 95%.

4.1 kW is being delivered to the grid. A snapshot of the solar array and\ power flow is below.

You can get a lot of power later in the day. Here it is at 4:23. The high load is due to EV charging.

T

The solar array is composed of Sharp and Panasonic panels. The Sharp were the original panels and the Panasonic were added when the system was upgraded to a SunStation. SunStation can operate even when the grid is down. It has a transfer switch that automatically cuts the link to the grid when the grid goes down. The battery capacity of 14 kWh is sufficient for about 5 days of operation when the solar input is zero. With normal sunlight, the home can operate indefinitely off-grid. There is no need for a fossil-fuel-based generator.

If you have an existing solar power system you would need to purchase a new inverter to charge batteries. An alternative is a Tesla Powerwall that connects to your AC wires and charges batteries by first rectifying the AC power. Some solar systems use micro-inverters that convert the solar panel’s DC power to AC power at each panel. These would also require something like the Powerwall.

The installation is shown below. The Outback Inverter is on the left. The Outback charges the batteries directly from DC power. The inverter is connected to the Mate3 interface which is connected to a NETGEAR range extender. The batteries are on the right in the cabinet. The battery management system is in the middle. The large boxes on the top prevent arc faults and are required by code. The box on the upper right is the power supply for those boxes. That functionality is now built into the inverters.

Here is a view of the roof. Notice the slight difference in color of the panels.

Contact us for more information and to get a quote!

You can find more information on geothermal from he linked blog post.

Renewable Home Power, Backup, Heat and Air Conditioning

Princeton Satellite Systems has been in a leader in renewable energy with its SunStation home solar power system with battery backup. We introduced this product back in 2013. SunStation has lithium-ion phosphate batteries, the most stable and reliable batteries for home use. The core of the system is the Outback Inverter that seamlessly switches from grid power to internal power.

The solar system in the installation produces 7.3 kW of power, much more than the house needed for electric power including charging a Nissan Leaf and Toyota Prius Prime. The heating and air conditioning system was nearing its end-of-life so we decided to replace it with a geothermal heat pump. A heat pump is essentially an air conditioner that can both reject heat to a source and absorb heat from a source. The problem with both is that when the outside temperature is high, for rejecting heat, and low, for absorbing heat, the system loses efficiency. Modern air-source heat pumps are very efficient but do need backup resistance heating in some climates.

A ground source heat pump, or geothermal heat pump, uses the ground as the medium for absorbing or rejecting heat. The option we chose, due to land constraints, is to have two wells several hundred feet deep as the source. Alternatives are trenching, or a pond if you have one in your yard. The ground is always at around 50 deg F. The system was sized so that it rarely, if ever, needs resistance heating.

The geothermal system, which is made by WaterFurnace, was installed by Princeton Air. No changes to the SunStation were needed. The core geothermal system is shown below. The valves to the ground loops are in the foreground and the geothermal system is on the left.

The lines that run to the outside ground loops are shown below.

The system has a preheater for the (still gas) hot water heater. The gas water heater was less than a year old, so it didn’t make sense to replace it. The preheater is an electric hot water heater that does not have the heating coils connected.

The SunStation is shown below. The Outback inverter is on the bottom left. The boxes on top provide arc protection, which is now included in the inverter. The batteries on on the right and the battery management electronics between the inverter and the battery cabinet.

The well digging was quite a project. This picture shows the drilling rig.

This second picture shows the yard after the drilling was complete. Drilling took three days total.

The following system shows the SunStation with geothermal in operation. The Prius Prime is charging which is most of the load. The system is still sending considerable power to the grid. On average the house powers itself and two other houses.

Geothermal, with solar and battery backup is the ideal solution for new homes and for renovations to existing homes. There is no reason to even have a gas hookup anymore. Contact us at SunStation for more information

SunStation in Operation!

SunStation is in operation! The system produces a peak of 7.8 kW solar power. It has 14 kWh of lithium batteries. The SunStation electronics are shown below. The inverter is on the left. The batteries are in the cabinet on the right.

SunStation

The SunStation has a web interface. You can see that when this screen shot was made the SunStation was selling 5.1 kW back to the power company! The batteries are fully charged. Usage was very small. The house has a whole house ventilator that is drawing most of the power. The homeowners also own a Nissan Leaf and a Toyota Prius Plugin. The solar array is enough to fully recharge those cars and run the house electrical devices when the air conditioning is not on.

SunStationWebInterface

Unlike gasoline, diesel or natural gas systems SunStation provides power year round! There is no noise and no toxic emissions. SunStation has no moving parts and is zero maintenance. Solar power systems are eligible for Solar Renewable Energy Credits which are cash payments for having an operating solar power system. It is estimated that this system will bring in $3700/year revenue between selling power and SRECs.